Floor Sanding in Bay Area, CA

Our services are mostly centered on home flooring, but we also operate in commercial settings. Our goal is to give you a stunning floor that will add value to your property.

Get the job done right. Talk to experts!

Customer satisfaction is our main priority, and we achieve it by providing you top-quality and affordable services.


reCaptcha Logo - Flooring Bay Area, FL
SSL Logo - Flooring Bay Area, FL
Active Campaign Logo - Flooring Bay Area, FL

Floor sanding in Bay Area: Hardwood floor Sanding or Refinishing 

Whether you're installing new hardwood floors and want to change the color to better match the tone of your home, you have existing hardwood that is looking worn out or scuffed up, or you're moving into a new home. The wood floors don't suit your taste; you have the option of sanding down, staining and refinishing them in a variety of situations. This allows you to truly personalize the wood and make it go in with the style of your home. Not all flooring, however, can be sanded and refinished. Our experts at floor sanding in Bay Area will discuss if you have this choice with your flooring and what can and cannot be sanded or resurfaced.

It is critical to determine if your flooring is solid or engineered hardwood. Unfortunately, floor sanders in CA cannot sand and refinish engineered flooring in the same manner as for solid hardwood. Due to a top layer of around 4 to 6mm, the thickest engineered floors can be sanded and refinished 3-5 times. Engineered wood with a 2mm or less wear layer cannot be sanded completely, although it can be refinished after a moderate scuff-sanding with a buffer.

If you're unsure if you have solid hardwood or engineered wood, look for vents or registers on the floor and remove the grille. This should allow you to see the wood's cross-section and the board's center adjacent to the register. If the board has the layers of plywood that an engineered wood has, you'll be able to tell. This examination can usually be done at an exterior entryway where the metal saddle can be removed. Yet, to ensure the quality of it, our sanding hardwood floors Bay Area crew is prepared to inspect it as well as its health.

The approach of our professionals at floor sanding in Bay Area for evaluating whether they are hardwood or engineered also works well for determining whether the boards are thick enough to refinish. In its lifetime, a full-thickness hardwood plank should be able to withstand between 6 and 10 refinishing. These are usually 3/4 of an inch thick. Due to varying milling standards, homes built before the 1920s commonly have flooring only 1/4 to 3/8 of an inch wide. This can only be sanded and refinished two or three times. If it is an older hardwood that has been restored once or twice, they are usually too thin to be refinished appropriately or even sanded.

Splintering can occur when sanding wood that is too thin. To be safe, it suggests that leave at least 1/8 of an inch of wood above the tongue and groove on most hardwood planks so that they can interlock. If the boards are thinner than 1/8 of an inch, refinishing it may be doable, yet working with our team at floor sanding in Bay Area rather than attempting it yourself is highly suggested, as the job is considerably riskier with thinner flooring. If it is too thin to sand, you can do a screening, which removes the old layer of finish without removing any wood and refinishes the floor with a couple of coats of finish to keep it looking new.

Let Us Preserve Your Wooden Floors For You! Connect With Us!

Suppose you are unsure whether your floors are thick enough to withstand a refinishing process. In that case, it is worth consulting with our floor sanding in Bay Area professionals to guarantee that you will not be hurting your floors if you undertake the project. Never begin sanding or refinishing it unless you are positive that there is enough wood in the boards to sand down.